2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 83Get this manual
6Inspect the seals for damageINSTALLING 1Lubricate the pressed-in swing arm bushings with light coat of grease; then install the spacer into the swing arm2If removed, install the rubber swing arm guard3Lubricate the two seals with light coat of grease; then install them on the ends of the swing arm4Position the swing arm in the frame and slide the long cap screw through the brackets and swing arm MD2315
7Remove the long cap screw and self-locking nut securing the front of the swing arm to the frame brackets; then remove the swing arm from the frameAccount for two seals, spacer, rubber swing arm guard, and washer
5Install the washer and self-locking nutTighten the nut to 50 ft-lbMD2007
6Install the axle, spacers, hubs, and drive chain (see Rear HubDrive Axle in Section 6)7Secure the shock absorber to the swing arm with the cap screwTighten the cap screw to 29 ft-lb