2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 82Get this manual
4Remove the four cap screws (A) securing the axle housing to the swing arm; then remove the axle housing MD2381
6Place the hub assembly onto the spindle; then install the washer and castle nutTighten the castle nut to 45 ft-lb; then install new cotter pinInstall the wheel and tighten the cap screws to 30 ft-lb7Remove the ATV from the support stand
! WARNING
After removing and installing components that are brake-related, ALWAYS check and adjust brakes as necessary before operating the ATV
Swing Arm
REMOVING 1Secure the ATV on support stand to elevate the rear wheels; then remove the wheelsKM212A