2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 81Get this manual
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
3Lubricate the steering knuckle assembly with grease; then install it into the A-arm and secure with the flanged castle nutTighten the nut to 29 ft-lb; then install new cotter pin and the rubber spindle pin boot
1Clean all A-arm components in parts-cleaning solvent2Clean the tie rod mounting hole of all residual Loctite, grease, oil, or dirt for installing purposes3Inspect the A-arm for bends, cracks, and worn bushings4Inspect the tie rod mounting holes for cracks or damage5Inspect the frame mounts for signs of damage or wearINSTALLING
NOTE: During installing, new cotter pins should be installedMD2427
4Install the tie rod end into the steering knuckle and secure it with the self-locking nutTighten the nut to 25 ft-lb; then install new cotter pin