2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 74Get this manual
3Install the drive chain (see Installing Drive Chain sub-section)4Adjust the drive chain slack (see Adjusting Drive Chain sub-section); then tighten the four cap screws (from step 1) to 29 ft-lbINSTALLING DRIVE AXLEREAR HUB 1Slowly slide the axle into the axle housingNOTE: The axle may have to be turned from side-to-side slightly during installing to get the axle through the center axle housing spacer
4Install the axle nuts securing the brake hub to the axle (see Drive TrainSprocketsInstalling Rear Sprockets in this section)5Install the drive chain (see Installing Drive Chain sub-section)6Install the rear wheelhub assembliesTighten the castle nuts to 58 ft-lb; then install new cotter pinsMD2364