2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 73Get this manual
NOTE: Do not remove more components than necessary to perform the intended serviceThe axle housing will separate from the swing arm with all components attached if necessary INSTALLING BEARINGS AND SEALS 1Using plastic mallet and bearing driver or appropriate size socket, carefully install the first bearing into the axle housing
4Remove the four cap screws (A) securing the axle housing to the swing arm; then remove the axle housing
KM226 KM217B
2Place the center axle housing spacer in the axle housing; then using plastic mallet, install the second bearingNOTE: It may be helpful to insert the axle through the previously installed bearing and into the axle housing to align the center axle housing spacer with the bearing boreAxle installation may be difficult if the spacer is offset from the bearing bore
3Apply light coat of axle bearing grease to the inside (mating surface) of the seals; then using plastic mallet, install the seals