2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 72Get this manual
REMOVING BEARINGS AND SEALS
Rear HubDrive Axle
REMOVING REAR HUBDRIVE AXLE 1Secure the ATV on support stand to elevate the rear wheels
1Secure the ATV on support stand to elevate the rear wheels
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
2Remove the wheels and hubs (see Removing Rear HubDrive Axle in this sub-section)3Using an appropriate prying tool, carefully pry out the seals from each side of the axle housing
2Remove the cotter pins from the castle nuts on the rear wheel hubs3Remove the rear wheel hub castle nuts; then slide the rear wheels and hubs off togetherAccount for the washers4Remove the two axle nuts securing the brake hub to the axle