2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 34Get this manual
Installing Left-Side Components AGEAR SHIFT POSITION SWITCH BSTARTER ONE-WAY CLUTCH CROTORFLYWHEEL DCENTRIFUGAL CLUTCH EV-BELTDRIVE CLUTCH DRIVEN PULLEY 1With the transmission in neutral, install new O-ring on the gear shift position switch; then orient the pin as shown and install the switch into the gear caseSecure with cap screw and tighten securely
7Install the push-bolt into the puller; then using two wrenches as illustrated, tighten the push-bolt until the one-way clutch is free of the crankshaft
NOTE: It may be necessary to strike the head of the bolt sharply with hammer after tightening to free the one-way housing from the crankshaft