2010 Arctic Cat DVX 90 / 90 Utility ATV Service Manual, Page 17Get this manual
Adjusting Shift Linkage If the ATV jumps out of gear, is difficult to get in gear, or the neutral and reverse indicator lights do not illuminate, shift linkage adjustment may be necessary1Shift the transmission into reverse; then remove the cap screw securing the linkage to the transmission shift armCD620
5Place the V-belt cover and one rear brake cable tab into position; then secure with the eight cap screws
2Verify that the transmission is in reverse, the ignition switch is in the ON position, the reverse indicator light is illuminated, and the shift lever is fully in the reverse position; then loosen the upper and lower jam-nuts on the shift linkage and adjust the linkage to align with the shift arm
6Tighten the cover cap screws to ft-lb7Install the cooling duct8Place the footrest cover into position and secure it to the footrest with the Phillips-head cap screwsTighten securely9Secure the footrest cover to the front and rear fenders with the Phillips-head cap screws and four cap screwsTighten securely