2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 125Get this manual
2Disconnect the negative battery cable first; then the positive cable3Remove the battery hold-down strap; then remove the battery4Remove the front and rear racks; then remove the cap screws securing the front center panel and remove the panel
7Disconnect the left and right headlight connectors; then disconnect the taillight8Remove the gas tank cover; then remove the shift knob and front and rear fenders
CLEANING AND INSPECTING
5Remove the cap screws and flange nuts securing the mud guards to the front and rear fenders; then remove the cap screws securing the mud guards to the front rests and remove the mud guards
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all body components with soap and water2Inspect the body and fenders for cracks3Inspect threaded areas of all mounting studs for stripping4Inspect for missing decalsINSTALLING (DVX) 1Fit the body over the handlebar and rotate into normal mounting position2Using the existing hardware, secure the front fenders to the fender supports; then connect the headlight