2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 122Get this manual
6Remove the steering post from the ATVCLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
2Apply thin coat of grease to the upper steering post bushing; then secure the steering post with the support blocks and existing hardwareTighten to 17 ft-lb
1Wash the tie rod ends in parts-cleaning solventDry with compressed airInspect the pivot area for wearApply low-temperature grease to the ends
! WARNING
Always wear safety glasses when using compressed air
2Inspect the tie rods for damaged threads or wear3Inspect the tie rods for cracks or unusual bends4Inspect all welded areas for cracks or deterioration5Inspect the steering post and steering-post holders for cracks, bends, or wear6Inspect the handlebar clamps for cracks or wear7Inspect the handlebar for cracks, wear, or unusual bends8Inspect the handlebar grips for damage or wear9Inspect the lower steering post support bearing and seal for wear or cracksINSTALLING 1Apply thin coat of grease to the lips of the lower steering post seals; then lower the steering post into position in the lower steering post bearingsKM595 KM589