2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 107Get this manual
6Align the swing arm assembly in the frame and engage the universal joint onto the splines of the secondary driven bevel gear shaft
10Tighten the final drive gear case drain plug securely; then remove the fill plug and level plug
KM131A KM532
7Install the right pivot bolt and left pivot adjusting bolt and tighten securely; then move the swing arm up and down to seat the bearingsTighten the left pivot bolt to 36 inlb and the right pivot bolt to 82 ft-lb8Install the left pivot lock nut; then while holding the left pivot adjusting bolt, use Pivot Lock Nut Wrench to tighten the lock nut to 82 ft-lb
11Pour the recommended gear lubricant into the fill hole until lubricant is visible on the threads of the level hole; then install the level plug and the fill plug and tighten securely12Install the rear drive gear case guard and tighten the cap screws securely13Apply grease to the brake disc hub and wheel hubs; then install the disc and rear hubs