2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 64Get this manual
6Tighten the nuts on the two rear and one front through-bolt to 29 ft-lb7Connect the shift linkage using the existing hardware8Install the output drive boot onto the bevel driven gear housing and secure with the existing clamp
11Connect the coolant temperature sensor; then connect the trigger coil connector, shift position connector, and stator connector
9Connect the V-belt cooling boots to the V-belt housing and secure with the existing hose clamps
12Install the coil (see Section 5)13Install the carburetor (see Section 4)14Install the muffler assembly (see Section 8)KM307A