2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 63Get this manual
12Connect the starter wire to the starter stud and secure with washer and nutTighten securely13Connect the stator connector, shift position connector, and the coolant temperature sensor; then secure the engine ground cable to the engine and tighten the cap screw securely KM331
2Lifting the front of the enginetransmission, move the assembly forward sufficiently to clear the rear engine mounts; then engage the secondary bevel driveshaft into the universal joint splines
14Install the coil (see Section 5)15Install the carburetor (see Section 4)16Install the exhaust pipemuffler assembly (see Section 8)17Install the gas tank (see Section 4)18Install the air filter housing (see Section 8)19Install the body (see Section 8)20Install the gas tank cover panel21Install the electrical trayInstall the battery and connect the positive cable; then connect the negative cable22Pour in the recommended amount and grade of engine coolant, engine oil, and transmission lubricant23Install the seatUtility 1Attach suitable engine lift to the front engine mounting boss; then lift the enginetransmission assembly into the frame from the left sideThe front of the enginetransmission should go in first