2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 51Get this manual
BWater Pump CTrigger Coil DStator Coil ERotorFlywheel
AT THIS POINT
To removeservice the water pump, see section 4
14Remove the right crankcase cover (see Section Water Pump)15Remove the trigger coil mounting screws; then remove the wire set plateKM692A
13To disassemble the secondary driven bevel gear assembly, use the following procedureASecure the universal joint using suitable vise; then engage the output end of the shaft with the universal jointKM772A
16Remove the three cap screws securing the stator coil to the crankcase cover; then remove the stator coil and trigger coil
CAUTION
BRemove the nut securing the driven bevel gear; then remove the gearAccount for washer
Use extreme care to avoid damaging or shorting the wiring