2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 21Get this manual
CheckingReplacing V-Belt REMOVING 1On the Utility, remove the left footwell; then remove the recoil starter assemblyOn the DVX, proceed to step 2KM245
2Install the brake pad retaining pin and secure with the clip pin; then install the dust cover
2Remove the front and rear V-belt housing cooling ductsKM244
3Burnish the brake pads (see Burnishing Brake Pads in this section)
3Remove the cap screws securing the V-belt cover noting the location of the different-lengthed cap screws for installing purposes; then using rubber mallet, gently tap on the cover tabs to loosen the coverRemove the coverAccount for two alignment pins and one gasket
Burnishing Brake Pads
Brake pads (both hydraulic and auxiliary) must be burnished to achieve full braking effectivenessBraking distance will be extended until brake pads are properly burnishedTo properly burnish the brake pads, use the following procedure