2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 20Get this manual
3Install the wheel and secureTighten to 32 ft-lb4Remove the ATV from the support standNOTE: Whenever installing new pads, the new pads must be burnished (see Burnishing Brake Pads in this section)
2Remove the brake spring plate; then remove the brake pads
MEASURINGREPLACING REARAUXILIARY BRAKE PADS (DVX) Removing
NOTE: The brake caliper on the DVX contains two sets of brake padsThe front pads are controlled by the main brake lever and the rear pads are controlled by the auxiliary brake pedal
1Remove the brake pad dust cover; then remove the clip pin and pull the brake pad retaining pin out of the caliper
Inspecting and Measuring 1Inspect the pads for gouges, chips, or wear2Inspect the disc for gouges, grooves, cracks, and warpage3Using calipers, measure the thickness of each brake pad4If the thickness of any brake pad is less than 1.0 mm (0.039 in, the brake pad must be replacedNOTE: The brake pads should be replaced as set