2010 Arctic Cat DVX 300 / 300 Utility ATV Service Manual, Page 17Get this manual
ADJUSTING SHIFT LEVER 1Place the shift lever in the (neutral) position; then set the engine stop switch to the STOP position and turn the ignition switch to the RUN positionThe neutral indicator light should illuminateNOTE: If the neutral indicator light does not illuminate, adjustment of the shift linkage will be requiredTo adjust, proceed to step 2 1With the master cylinder in level position, check the fluid level in the reservoirIf the level in the reservoir is not visible in the sight glass, add DOT brake fluid
2Loosen the jam nuts on both ends of the shift rod and turn the shift rod until the neutral light illuminatesTighten the jam nuts securely
NOTE: On the DVX 300, the neutral position in the transmission is indexed by passing Phillips screwdriver through the transmission shift arm and into the index hole in the transmission cover
2Compress the brake leverpedal several times to check for firm brakeIf the brake is not firm, the system must be bled3To bleed the brake system, use the following procedureARemove the cover and fill the reservoir with DOT Brake FluidBInstall and secure the cover; then slowly compress the brake lever several timesCRemove the protective cap, install one end of clear hose onto one FRONT bleed screw, and direct the other end into container; then while holding slight pressure on the brake lever, open the bleed screw and watch for air bubblesClose the bleed screw before releasing the brake leverRepeat this procedure until no air bubbles are present