2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 178Get this manual
2Slide the grommet out of the lower half of the throttle control; then remove the cable from the actuator arm DE058A
2Using two new crush washers, connect the banjo-fitting to the master cylinder; then secure with the banjo-fitting boltTighten to 20 ft-lb
3Remove the cap screw, lock washer, and washer securing the actuator arm to the throttle control lever
3Gently press the brakelight switch into the housing (left to right) until the mounting tabs snap into the four locating holes; then install the brake lever, pivot pin, and snap ring