2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 170Get this manual
NOTE: It may be necessary to rotate the body panel to the right to align the opening with the handlebar
3Make sure the rubber grommets and bushings are in place; then place the front rack into position and secure with the screws and flange nutsTighten securely4Install one cap screw and flange nut and four plastic rivets on each side to secure the front fenders to the footwellsTighten the flange nuts securelyNOTE: If the footwells have been removed, see Footrests in this section
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all fender components with warm soap and water solution2Inspect fenders for cracks andor loose rivets3Inspect for any missing decalsINSTALLING 1Rotate the handlebar to the full-left position; then place the front body panel over the handlebar and rotate and lower into position