2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 148Get this manual
CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
1Clean all hub components2Inspect all threads for stripping or damage3Inspect the brake disc for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING 1Secure the brake disc to the hub with the four cap screws coated with blue Loctite #243Tighten to 15 ft-lb2Apply grease to the splines in the hub
6Tighten the hub nut (from step 4) to 200 ft-lb; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut
7Install the wheel and tighten to 45 ft-lb8Remove the ATV from the support standPR291
3Install the hub assembly onto the shaft
Hydraulic Brake Caliper