2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 146Get this manual
INSTALLING FRONT DRIVE AXLE 1Position the drive axle in the gear case and steering knuckle; then insert the upper A-arm ball joint into the steering knuckleSecure with cap screw tightened to 50 ft-lb2Place the brake hose into position on the upper A-arm; then secure the lower shock eyelet to the A-arm with cap screw and new lock nutTighten to 50 ft-lb3Secure the tie rod to the steering knuckle with new lock nutTighten securely; then install and spread new cotter pin4Slide the hub wbrake disc into position in the steering knuckle followed by washer and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckleTighten to 20 ft-lb; then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step 4) to 200 ft-lb; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut CD024
8Inspect the axle components for correct positioning of the four clampsAlso, inspect the boots for being correctly positioned on the shaftINSTALLING REAR DRIVE AXLE 1Slide the drive axle into place in the gear caseNOTE: To assure proper seating of the axle, give it light pull; the axle should remain "clipped" in place