2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 120Get this manual
1Turn the ignition switch to the ON position2Set the meter selector to the OHMS position3Connect the red tester lead to the red wire; then connect the black tester lead to the redblack wire4The meter must show less than ohm5Turn the ignition switch to the LIGHTS position6Connect the red tester lead to the red wire; then connect the black tester lead to the redblack wireCD070
7The meter must show less than ohm8Connect the red tester lead to the red wire; then connect the black tester lead to the gray wire9The meter must show less than ohm10With the switch in the OFF position, connect the red tester lead to the red wire and the black tester lead to each of the remaining wiresThe meter must show an open circuit on all wires11Connect the red tester lead to the red wire and the black tester lead to the brown wireWith the switch in the ON position, the meter must show 980-1020 ohmsNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness