2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 96Get this manual
27Install new O-rings on the oil sump and return pipes; then apply oil-soluble grease on the O-rings and place the oil pan into position
30Install the coolant bypass hose and secure with the support clamps and two Allen-head cap screws to the two hollow studs; then secure the bypass hose to the fittings with the hose clampsTighten securely31Install new crankshaft seal in the rear engine seal flange; then apply small amount of RTV Silicone to the extended ends of the lateral seals
28Secure the oil pan with the Allen-head cap screws and the two hollow studs and spacers making sure to install the two hollow studs at the outside corners on the crankshaft pulley side; then using crisscross pattern, tighten to ft-lb