2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 82Get this manual
12Apply Three Bond Sealant to the secondary output shaft bearing housing; then install on the transmission and tighten securely
14Install the left and right transmission mounting brackets and tighten the cap screws securelyThe transmission is now ready to be installed on the V-belt housing
Center Components
NOTE: This procedure cannot be done with the engine in the frameComplete Removing procedures for Top-Side, Left-Side, and Right-Side must precede this procedureNOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment