2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 78Get this manual
2Using suitable press, install the driven gear (C) on the shaft until the gear firmly seats on the shoulder of the shaft
4Install new seal (F), output yoke (G), and nut (H) and tighten to 72 ft-lb
MT008B MT011B
3If installing the existing shaft, start with the shims removed during disassembly or if installing new shaft, start with approximately 1.0 mm shims at point (D); then install the output driveshaft bearing (E) making sure the locating pin is directed toward the center of the shaft
NOTE: Do not use new lock nut at this time as this procedure may have to be repeated