2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 71Get this manual
16Heat the retaining nut on the secondary output shaft; then holding the gear assembly securely, remove the retaining nutAccount for the shims DE139
14Remove the countershaft assembly (E)Account for thrust washer on each end noting the different sizes
17Using an appropriate seal removal tool, remove any damaged seals from the transmission case18Remove the snap ring securing the output drive bearing in the right-side case; then using appropriate bearing drivers, remove the appropriate bearings
15Remove the reverse idler gear (F)Account for the axle, bushing, and two thrust washers