2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 68Get this manual
1Lay the flywheelring gear assembly on flat surface with the PTO side up; then using cold chisel and hammer, score the ring gear in several locations around the circumference Installing 1Using new gasket, secure the V-belt housing to the engine block with the four countersunk cap screws tightened to 25 ft-lb; then install the flywheelPTO shaft on the crankshaft and using the pattern shown, tighten the five cap screws to 40 ft-lb
2Turn the flywheelring gear assembly over and support on suitable block so that the ring gear is free to be driven from the flywheel; then using punch and hammer, tap the ring gear off the flywheel