2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 60Get this manual
8In the same pattern, tighten each cylinder head bolt 90; then tighten an additional 90 using the same pattern DE349
CAUTION
Failure to remove oil or coolant from bolt bores may result in hydraulic lock when installing head boltsThis will cause severe engine block damageDE575C
CAUTION
Head bolts must be tightened in the proper sequence and in steps or engine damage may occur
4Place the cylinder head gasket onto the cylinder deck aligning the gasket on the alignment pins; then carefully install the cylinder head onto the engine block aligning the head to the index dowels
9Install the rocker arms (see CamshaftRocker Arms in this sub-section)10Install the unit injectors (see Top-Side Components in this section)11Adjust the valves (see Top-Side Components in this section)12Check and adjust static injector timing (see Top-Side Components in this section)13Install the engine and transmission (see Installing EngineTransmission in this section)