2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 50Get this manual
4Rotate the engine clockwise until either cylinder is at TDC as shown in the following illustration 8Rotate the crankshaft clockwise 180 and repeat steps 5-7 on the other cylinder
AT THIS POINT
If engine is being assembled, static injector timing should be adjusted (see Top-Side Components in this section)
9Place small bead of high-temperature sealant on the fuel rail seal; then carefully install the valve cover with new gasket and oil return bootUsing crisscross pattern, tighten the Allen-head cap screws to 6.5 ft-lb; then tighten the two "tamper-proof" torx-head cap screws to 6.5 ft-lbDE557A
5Using an appropriate thickness gauge, check the clearance between the camshaft follower and camshaftDE406