2010 Arctic Cat 700 Diesel SD ATV Service Manual, Page 11Get this manual
6After charging the battery for the specified time, remove the battery charger and allow the battery to sit for 1-2 hours7Connect the multimeter and test the battery voltageThe meter should read at least 12.5 DC VoltsIf the voltage is as specified, the battery is ready for serviceNOTE: If voltage in step is below specifications, charge the battery an additional 1-5 hours; then retest Air Filter
Use the following procedure to remove the filter and inspect andor clean itCLEANING AND INSPECTING FILTER
CAUTION
Failure to inspect the air filter frequently if the vehicle is used in dusty, wet, or muddy conditions can damage the engine
8Place the battery in the battery tray; then coat the battery posts and cable ends with light coat of multi-purpose grease
CAUTION
Before installing the battery, make sure the ignition switch is in the OFF position
NOTE: This ATV is equipped with dry-paper air filter and cotton-fabric safety element