2009 Arctic Cat Prowler XTZ ATV Service Manual, Page 154Get this manual
6Install the cotter pins and spread to secure7Install the wheels and tighten to 45 ft-lbCheck the steering system for full and free travel; then check and adjust the front wheel alignment (see CheckingAdjusting Front Wheel Alignment in this section) 3Install the hairpin clip on the steering shaftNOTE: If the hole in the steering shaft does not align with the slots in the castle nut, tighten the nut slightly until the next slot aligns with the hole
Steering Wheel
REMOVING 1Remove the steering wheel cover; then match mark the steering shaft and steering wheelNOTE: Any time steering components are disassembled, all connecting components should be marked for proper alignment during assemblingPR684A
2Remove the hairpin clip from the steering shaft; then remove the nut securing the steering wheel and remove the steering wheelAccount for the flat thrust washer and two wave washers
Upper Steering Shaft