2009 Arctic Cat Prowler XTZ ATV Service Manual, Page 136Get this manual
2Using suitable seal driver, install new oil seal into the front of the input housing until the seal flush with the housing
5Using new gasket, install the assembled rear drive input shafthousing onto the rear drive gear case and secure with the three cap screwsTighten to 23 ft-lb
AT THIS POINT
For servicing the input shaft, pinion gear, needle bearing, and axle seal, see Front Differential in this section
INSTALLING 1Slide the gear case into position down through the upper-left side of the frame; then align the driveline splines to the input coupler and engage the driveshaft and gear caseGZ182A