2009 Arctic Cat Prowler XTZ ATV Service Manual, Page 111Get this manual
NOTE: If any meter reading is not as specified, replace or adjust the TPS (see INSTALLINGADJUSTING in this sub-section) 7Connect the positive lead to the battery; then connect the negative lead8Connect the main harness TPS connector to the TPS; then using MaxiClips, connect the black tester lead to the black wire and the red tester lead to the greenblack wirePR538A
4Remove the black tester lead from terminal and connect it to terminal CThe meter should read 5.0 DC voltsNOTE: If the meter does not read as specified, check for poor connections at the ECU or openbroken wires in the wiring harness
! CAUTION
Always make sure the ignition switch is in the OFF position before disconnecting the ECUPR546A
5Turn the ignition switch to the OFF position; then disconnect the battery (negative cable first)
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
9Select the DC Voltage position on the meter and turn the ignition switch to the ON positionThe meter should read approximately 0.6 DC volts with the throttle closed and approximately 5.0 DC volts with the throttle in the full-open positionNOTE: If the meter readings are as specified, check the main harness connector at the ECU main harness wiringIf the meter readings are not as specified, replace the TPS and adjust to specifications (see INSTALLINGADJUSTING in this sub-section)