2009 Arctic Cat Prowler XTZ ATV Service Manual, Page 109Get this manual
2After ten seconds, release the reverse override switch and turn the ignition switch to the OFF position; then turn the ignition switch to the ON positionThe display should read AC00 (no fault detected)NOTE: If the LCD still displays an error code, continue troubleshooting the appropriate component 3Disconnect the test plug; then install the black rubber capATV-112
4Turn the ignition switch to the ON position and read the error code on the LCDRefer to the following ECU Error Code List to identify the specific problem areaECU Error Code List
NOTE: Each of the following numerical codes will have two-letter prefixA prefix of AC (Active Code) or SC (Stored Code) will be displayedAlways correct and clear Active Codes before clearing Stored Codes No Fault Detected (active code only) CKP (Crankshaft Position) Sensor MAP (Manifold Absolute Pressure) Sensor TPS (Throttle Position Sensor) ECT (Engine Coolant Temperature) Sensor Speed Sensor IAT (Inlet Air Temperature) Sensor Tilt Sensor Ignition Coil #1 Ignition Coil #2 Fuel Injector #1 Fuel Injector #2 ISC (Idle Speed Control) Valve Fuel Pump Relay Cooling Fan Relay Sensor Power Incorrect ECU ECU Memory Power (constant battery power) 98ECU to Gauge Com Link 99StartRun Not Possible (active code only)