2009 Arctic Cat Prowler XT/XTX ATV Service Manual, Page 107Get this manual
Front Drive Actuator NOTE: With the engine stopped and the ignition switch in the ON position, momentary "whirring" sound must be noticeable each time the selector switch is moved to 2WD and 4WDTest the switch, 30 amp fuse, and wiring connections prior to testing the actuatorNOTE: The differential must be in the unlocked position for this procedure
NOTE: If battery voltage is not shown, troubleshoot the 10 amp ignition (IGN) fuse on the power distribution module, the ignition switch, or the main wiring harness
4Connect the red meter lead to the whitered wireThe meter must show battery voltage5Select 4WD on the 2WD4WD selector switchThe meter must show DC volts6Connect the red meter lead to the whiteorange wireThe meter must show battery voltage7Engage the differential lockThe meter must show DC voltsNOTE: If the meter does not show DC volts, rock the vehicle to help engage the differential lock; then troubleshoot the differential lock switch (see Differential Lock Switch (XT) in this section)
VOLTAGE 1Locate the 4-wire connector for the front drive selector actuator on the frame to the right of the differential; then connect the red meter lead to the orange wire using MaxiClip