2009 Arctic Cat Prowler XT/XTX ATV Service Manual, Page 105Get this manual
NOTE: If the meter does not show battery voltage, troubleshoot the LIGHTS fuse on the power distribution module, the ignition switch, or the main harness VOLTAGE
NOTE: Voltage tests must be made with the switch and the actuator connectedThe meter can be connected at the actuator connector using break-out harness or MaxiClips
3Connect the red meter lead to the yellow wire; then select the high beam position on the headlight switchThe meter must show battery voltage4Connect the red meter lead to either of the two white wires; then select the low beam position on the headlight switchThe meter must show battery voltageNOTE: The battery voltage will show lower in steps and due to electrical loading of the headlights
1Connect the black tester lead to the black wire; then turn the ignition switch to the ON position2Select the DC Volts position on the tester and observe the meter readings for each of the three switch positionsWIRE COLOR 2WD 4WD DIFFERENTIAL LOCK
12.0 DC Volts DC Volts DC Volts
2WD4WDDifferential Lock Switch