2009 Arctic Cat 90 ATV Service Manual, Page 89Get this manual
! WARNING Do not mix tire tread patternsUse the same pattern type on front and rearFailure to heed warning could cause poor handling qualities of the ATV and could cause excessive drive train damage not covered by warranty
TIRE INFLATION PRESSURE Front and rear tire inflation pressure should be 0.21 kg-cm2 (3.0 psi)MD2014
9Place the axle housing into position on the swing arm; then install and tighten four cap screws to 29 ft-lb10Install the brake caliper on the axle housing with the two cap screwsTighten securely
! WARNING
Always maintain proper tire inflation pressure
REMOVING 1Secure the ATV on support stand to elevate the wheels
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
2Remove the four cap screws securing each wheel; then remove the wheelsNOTE: Keep left-side and right-side wheels separated for installing them on their proper sides
11Install the wheels and tighten the cap screws to 30 ft-lb; then remove the ATV from the support stand