2009 Arctic Cat 400/500/550/700/550/700/1000 ATV Service Manual, Page 267Get this manual
RESISTANCE (Switch Connector)
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
NOTE: The brake lever must be compressed for this testAlso, the ignition switch must be in the OFF position
1Set the meter selector to the OHMS positionAR626D
3When the brake pedal is depressed, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, replace the switch
2Connect the red tester lead to one black wire; then connect the black tester lead to the other black wire
Brakelight Switch
(Handlebar Control)
To access the connector, remove the access panelNOTE: The ignition switch must be in the ON positionAR621D