2009 Arctic Cat 400/500/550/700/550/700/1000 ATV Service Manual, Page 125Get this manual
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 7From the left side, install the case half mm cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
8From the right side, install the mm cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to ensure no binding or sticking occursCD818
9In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 5-6) until the halves are correctly joined; then tighten to 16 ft-lbNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
3Raise the rear of the engine and place block beneath it; then install the propeller shaft and output flange into the rear drive coupler
10In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 7-8) to ft-lbNOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs