2009 Arctic Cat 366 ATV Service Manual, Page 121Get this manual
6Apply grease to the hub and drive axle splines; then install the hub assembly onto the drive axle7Secure the hub assembly with the nutTighten only until snug8Secure the brake caliper to the knuckle with the two patch-lock cap screwsTighten to 20 ft-lb9Secure the hub nut (from step 7) to the shaftaxleTighten to 200 ft-lb10Install new cotter pin and spread the pin to secure the nutKC297
8Remove the lower shock absorber eyelet from the upper A-arm9Remove the cap screws securing the A-arms to the frame10Remove the circlip from the ball joint; then remove the ball joint from the A-armCLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
11Install the wheel and tighten to 40 ft-lb12Remove the ATV from the support stand
Rear A-Arms