2009 Arctic Cat 366 ATV Service Manual, Page 115Get this manual
INSTALLING 1Slide the gear case into position through the left side of the frame; then secure it to the frame with cap screws and lock nutsTighten to 45 ft-lb2Secure the engine output shaft to the rear gear case input flange with four cap screws (coated with red Loctite #271) and lock nutsTighten to 20 ft-lb3Install the rear drive axles (see Drive Axles in this section) 4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING 1Secure the brake disc to the hub with the four cap screws coated with blue Loctite #243Tighten to 15 ft-lb2Apply grease to the splines in the hub3Install the hub assembly onto the shaft4Secure the hub assembly with the nutTighten only until snug5Secure the brake caliper to the knuckle with the two cap screwsTighten the caliper to 20 ft-lb
REMOVING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury