2009 Arctic Cat 366 ATV Service Manual, Page 49Get this manual
Removing Left-Side Components ACoverStator Assembly 1Remove the cap screws securing the outer magneto cover and remove the cover2Remove the left-side cover-to-crankcase mounting cap screws noting the location of the mm cap screw with the washer near the middle of the left-side coverKeep the different-lengthed mm cap screws in order for installing purposes
NOTE: Inspect the inside of the left-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover
BRotorFlywheel CStarter Motor
NOTE: Steps 1-3 in the preceding sub-section must precede this procedure