2009 Arctic Cat 150 ATV Service Manual, Page 87Get this manual
3Lubricate the steering knuckle assembly with grease; then install it into the A-arm and secure with the flanged castle nutTighten the nut to 32 ft-lb; then install new cotter pin and the rubber spindle pin boot
6Place the hub assembly onto the spindle; then install the washer and castle nutTighten the castle nut to 50 ft-lb; then install new cotter pinInstall the wheel and tighten the lug nuts to 32 ft-lb
Wheels and Tires
TIRE SIZE
! WARNING
Use only Arctic Cat approved tires when replacing tiresFailure to do so could result in unstable ATV operation
4Install the tie rod end into the steering knuckle and secure it with the self-locking nutTighten the nut to 32 ft-lb; then install new cotter pin