2009 Arctic Cat 150 ATV Service Manual, Page 29Get this manual
CleaningInspecting Piston Rings 1Take an old piston ring and snap it into two pieces; then grind the end of the old ring to 45 angle and to sharp edge2Using the sharpened ring as tool, clean carbon from the ring-groovesBe sure to position the ring with its tapered side up 3Insert an inside dial indicator into the piston-pin boreThe diameter must not exceed specificationsTake two measurements to ensure accuracy
! CAUTION
Improper cleaning of the ring-grooves by the use of the wrong type of ring-groove cleaner will result in severe damage to the piston
Measuring Piston-Ring End Gap (Installed) 1Place each piston ring in the wear portion of the cylinderUse the piston to position each ring squarely in the cylinder2Using feeler gauge, measure each piston-ring end gapAcceptable ring end gap must not exceed specificationsATV-1069
Measuring Piston Skirt Cylinder Clearance 1Measure the cylinder front to back in six places