2008 Arctic Cat ThunderCat ATV Service Manual, Page 150Get this manual
NOTE: The distances from the inside rims to the frame tubes should be equalIf the measurements are equal, proceed to step 8; if the measurements are not equal, proceed to step 7
9Measure the distance between the marks (at height parallel to the belly panel) at the front side; then record the measurement10Push the ATV forward until the marks are parallel to the belly panel on the back side; then measure the distance between the marks11The difference in the measurements must show 18-14 intoe-in (the front measurement 18-14 inless than the rear measurement)12If the difference in the measurements is not within specifications, adjust both tie rods equally until within specificationsNOTE: Prior to locking the jam nuts, make sure the ball joints are at the center of their normal range of motion and at the correct angle