2008 Arctic Cat ThunderCat ATV Service Manual, Page 133Get this manual
3Place the brake caliper assembly into position and secure with the cap screwsTighten the caliper to 20 ft-lb4Place new crush washer on each side of the brake hose fitting and install it on the caliperTighten to 20 ft-lb5Fill the reservoir; then bleed the brake system (see Section 2)6Install the wheelTighten to 40 ft-lbPR239
7Remove the ATV from the support stand and verify brake operation
Troubleshooting Drive System
Problem: Power not transmitted from engine to wheels Condition
1Rear axle shafts serration wornbroken Condition 1Secondary drivedriven gear teeth broken 2Propeller shaft serration wornbroken 3Coupling damaged 4Coupling joint serration worndamaged 5Front drivedriven bevel gears brokendamaged 6Front differential gearspinions brokendamaged 7Sliding dogsshaft fork worndamaged 8Front drive axle worndamaged 9Front drive axle serration worndamaged