2008 Arctic Cat ThunderCat ATV Service Manual, Page 102Get this manual
0012131415162123242632344041609596979899 =
No Fault Detected (active code only) CKP (Crankshaft Position) Sensor MAP (Manifold Absolute Pressure) Sensor TPS (Throttle Position Sensor) ECT (Engine Coolant Temperature) Sensor Speed Sensor IAT (Inlet Air Temperature) Sensor Tilt Sensor Ignition Coil #1 Ignition Coil #2 Fuel Injector #1 Fuel Injector #2 ISC (Idle Speed Control) Valve Fuel Pump Relay Cooling Fan Relay Sensor Power Incorrect ECU ECU Memory Power (constant battery power) UART Comm Link StartRun Not Possible (active code only)
SUPPLY VOLTAGE 1Disconnect the three-wire connector from the sensor; then select DC Voltage on the multimeter and connect the red tester lead to the orange wire (C) and the black tester lead to the black wire (A)
Will initiate code 99
To clear the error code(s), use the following procedureNOTE: The ignition switch should be in the OFF position