2008 Arctic Cat ThunderCat ATV Service Manual, Page 96Get this manual
RESISTANCE (Emergency Stop) 1Set the meter selector to the OHMS position2Connect the red tester lead to the orange wire; then connect the black tester lead to the orangewhite wire3With the switch in the OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness RESISTANCE
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter