2008 Arctic Cat ThunderCat ATV Service Manual, Page 80Get this manual
FuelLubrication Cooling NOTE: Arctic Cat recommends the use of new gaskets, lock nuts, and seals and lubricating all internal components when servicing the enginetransmissionNOTE: Some photographs and illustrations used in this section are used for clarity purposes only and are not designed to depict actual conditionsNOTE: Critical torque specifications are located in Section 1
NOTE: fully-charged battery must read at least 12.5 DC voltsno loadA minimum of 8.5 DC volts under load is necessary for the EFI system to operate
5Check the air filter housing and air filter for contaminationClean or replace as necessary (see Section 2)REMOVING
! WARNING
Whenever the gasline hoses are removed (other than for pressure testing), the battery must be disconnected to prevent inadvertent activation of the electronic fuel pump
SPECIAL TOOLS number of special tools must be available to the technician when performing service procedures in this sectionDescription
Oil Pressure Test Kit Seal Removal Tool Tachometer
1Remove the front rack and body panel (see Section 8)2Disconnect the wires from the IAT sensor; then loosen the clamp and remove the inlet air boot from the air filter housing