2008 Arctic Cat ThunderCat ATV Service Manual, Page 76Get this manual
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs AT THIS POINT
After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to Installing Top-Side Components
Installing EngineTransmission
NOTE: Arctic Cat recommends that new gaskets and O-rings be installed whenever servicing the ATV
4Align the rear output drive flange and the rear driveshaft yoke flange and install the cap screwsTighten to 20 ft-lb5Align the engine with the mounting brackets and install the through-bolts with flat washers; then install the flange nuts and tighten to 45 ft-lb6Connect the coolant hose and tighten the clamps securely7Secure the engine and harness grounds to the engine and tighten the cap screw to ft-lb